Mouse

[HeikkiH]

quote:
Heikki - a few old bearings, 2 gears from an old motorbike and some box section steel, turn a couple of parts on the lathe for the rollers

Simple and cost effective. Nice

Do those arms have any significant flex when working? Aluminium is soft, but I think that with steel you would have start easy and roll back and forth several times before wanted depth is achieved. I guess I use similar, but much sturdier design so I get wanted rill depth on a one run.

Heikki H.

FJDC
Montenegros #21


Edited by - 4x4_76 on 17/03/2008 19:26:55