12H-T perusremppa ja hihnapyörän irroitus

[osilpi]

Sain Australiasta vastauksen kysymykseeni:

""""
G'day Ossi,
yes we can help you with all the above,
we have pistons in .5mm and 1.00mm oversize and a full range of undersize bearings so just need to know what sizes you need.
the gasket set has turbo mounting gaskets but not 100% sure on the seals- their is a large pack in the kit with heaps of o-rings and seals but i do not have a breakdown of what each one is but presume it has what you need.
our diesel engine kits we only send via tnt air international courier and are fully insured with web tracking,
delivery time is normally 5-10 working days and we need approx 2-3 days to put the kit together for you depending on sizes needed.
so we can supply:
1 X ENGINE REBUILD KIT
12 X VALVE GUIDES
6 X STELLITE EXHAUST VALVES
6 X INLET VALVES
12 X LIFTERS
1 X BRAND NEW CAMSHAFT
all the above including delivery is $2500.00aus.
we can supply a 2nd hand re-ground cam instead of a new one and this would be $2100.00aus.
just let me know if you need to order,
regards neil lowerson
ROODOGS 4WD SPARES


Engine rebuild kit=
6 X PISTONS, 1 X MAIN BEARING SET,1 X THRUST BEARING SET,1 X CONROD BEARING SET,1 X FULL GASKET & SEAL SET,6 X PIN BUSHES,1 X SET RINGS,1 X CAM BEARING SET,1 X TUBE 02 SAFE SEALANT,1 X BONUS FITMENT PACK,1 X SPEC SHEET

"""""

Ja pelkkä engine rebuild kit siis joku 1600aussia toimitettuna.

karkeat hinnat forexin mukaan:
2500AUS = 1600€
2100AUS = 1300€
1600AUS = 1000€

Ei kyllä paha ollenkaan... Voisi melkein ottaa tuon kaikista laajimman setin (tai sitten korjatulla nokalla), kohan koneistamo ensin sanoo mielipiteensä lohkosta ja kannesta (eli onko halkeamia ja mikä ylikoko pitäisi männillä olla).

Mielipiteitä??? Puuttuuko jotain, mitä pitäisi olla?

HJ 60 -82