90 Cherokee XJ rebuilding

[sms1878]

valve body mods with diagrams and marks on the plate.

the check balls re-located according to toyota diagrams.

bought new oil pump seal. FPM type. 22euros.

[sms1878]

re-positioned check-balls in valve-body and end of story with transmission.

[sms1878]

all set. finished with torque convertor. primed the shafts.

[Bonne]

Neat work sms1878! What primer/top coat you are using on the parts? For example on the engine/tranny/casings etc which will be in hot conditions, what kind of primer to be used in order to keep it from flaking off after short while? I have probably made some shortcuts while cleaning/preparations prior to the painting...

Thanks in advance..

[sms1878]

Alkuperäinen kirjoittaja Bonne

Neat work sms1878! What primer/top coat you are using on the parts? For example on the engine/tranny/casings etc which will be in hot conditions, what kind of primer to be used in order to keep it from flaking off after short while? I have probably made some shortcuts while cleaning/preparations prior to the painting...

Thanks in advance..

hey thanks. i ll put them one by one

engine block: no primer. cleaned with metal brush and driller then wiped with thinner. used brake caliper paint. needed a bit thicker coat.
transfer case: aluminum primer up to 220c and hot black paint up to 600c.
transmission is same as transfer case.
intake manifold and valve cover: silver hot paint up to 400c.
exhaust manifold: not painted yet but looking for vht 1300c black paint to buy.
drive shafts: applied regular primer, will use with brake caliper paint.

hopefully they will all hold.

[sms1878]

i should get back to work on this if i will have time from work this summer

[poksutin]

Please continue.... I wanna hear it purrrr