90 Cherokee XJ rebuilding

[sms1878]

removed the carpet and usual ones

[sms1878]

removed interior parts all of them. including console but still in that pic :P

[sms1878]

quick check on injectors. 3 out of 6 were fine. cleaned them up with ultrasonic cleaner.
got better ohm values after cleaning. from 14.8 to 16.5 ohms something.

[sms1878]

here comes the cylinder head off.

[sms1878]

rocker arms and cam shifters before cleaning and after 2 rounds of 15 min with ultrasonic cleaner. now left them de greaser for night to get all dirt out.

[sms1878]

pics here.

[sms1878]

needed something to keep the engine hanging and adjust... wanted to do it before putting it back.

[Mase]

Alkuperäinen kirjoittaja sms1878

rocker arms and cam shifters before cleaning and after 2lrounds of 15 min with ultrasonic cleaner. now left them de greaser for night to get all dirt out.

Maybe you should open hydraulic lifters to get dirt out from them. There is small snapring in top of lifter, after that piston and valve will come out and you can clean lifter from inside and check inner bore condition also. Dont mix pistons and valves to other lifters, and becarefull snaprings will fly cross the room when you twist it avay with skrewdriver!

[sms1878]

Alkuperäinen kirjoittaja ford59

Maybe you should open hydraulic lifters to get dirt out from them. There is small snapring in top of lifter, after that piston and valve will come out and you can clean lifter from inside and check inner bore condition also. Dont mix pistons and valves to other lifters, and becarefull snaprings will fly cross the room when you twist it avay with skrewdriver!

thanks, I guess I will open them too. those passages didn't seem so clean at all. I don't have every right tool so I need to figure out something to open them.