Daihatsu Rocky ja Romania

[Cristian1]

Hei!

Nimeni on Cristian, olen Romaniasta ja minä omistan Daihatsu Rocky 2.8D ja Opel Frontera 2.0.
Daihatsul on `90, kiertää 31/10.5x15 B&P Pneus Extrem (Romania tuotanto, kopioi SIMEX) GrandVitara pyörät käännetään.
Edessä on 9,5 Ironman vinssi teräsvaijeriin ja levy valmistettu MAN kuorma-auton alustalle.
Sillä kun minä dokumentit, joissa voin, niin voin antaa lehtijouset ja kela asentaa.Ongelmana on, että Rocky on etäisyys karan ja rungon liian pieni ja tuskin löytänyt joitakin jouset Mercedes W124 .... toivottavasti se ei ole liian kova. Muistelen kumpuavat Vitara, luulevat, että olen ok?

Toivon, että ymmärrätte jotain, käänsin Google.

[LaaLaa]

Hi Christian,
Google translator is so bad that it's impossible to understand your message correctly.
Please write your messages in english, most of the peaople here understand it better than google translator chaos.

If I understood right, you asked about good coil spring alternatives for your Daihatsu Rocky? MB124 coil spring might be good for Rocky. Vitara front coils might be too stiff and rear coils too soft.

[AlluK]

Dracula car

[Mojoman]

Transylvanian Express

Welcome to the Forum!

[Cristian1]

I want to put W124 springs in front and rear Vitara front. It's here on the forum any Rocky converted to coils, but has original axles?
Worries me distance between spindle and chassis. It is very small (~ 11cm) and the W coils, has 98mm diameter...

Yes, @AlluK, I live at 40 km from Sighisoara city of Dracula, there is a strong off-road club.

[LaaLaa]

Can you cut some material away from frame and make a spring cup from right size metal tube? That way you could move spring few cm away from spindle/knuckle. Like this how I made it for my Suzuki lwb (weldings are just for test fitting in pic)

[Cristian1]

Interesting method! But I think it's too risky in front of Rocky because is support of Panhard bar and after, is the support of the engine ... But is good method !
Regarding the type of suspension I have a dilemma ...
-To put radius arms on Pajero / Defender
-Or 3link. But 3 link + Panhard is ok if you fixed in the same point with upper link and lower link bolt ?