silly question
This may sound silly, but trying to understand what I need to rebuild these axles.
I know I need the large oil seal and adapter ring, pictured. I assume there are four of these???
I need the boot. are there four of these also?
Here is what I have bought already, 4 different bearings and only two seals (only two each.??)
Drive gear (upper/small gear) _ I have four of each of these…..
SKF/FAG 6210 (single row radial ball, open) - dims: 50x90x20
INA BK4520 (drawn cup closed needle bearing) - dims: 45x52x20
Driven gear (lower/large gear)
Timken JLM104948 (tapered roller/cone) same as LC
Timken JLM104910 (tapered race/cup) same as LC
Timken JLM508748 (tapered roller/cone)
Timken JLM508710 (tapered race/cup)
Seals, - I only have 2 of each of these…. Do I need four????
CR 23451 (STEFA, BB - dims:60x85x8), upper portal/axle tube oil seal
CR 19687 (STEFA, BB - dims:50x90x10), inner hub grease/oil seal
|