10.04.2018, 12:37
|
Konkari++
|
|
Rekisteröitynyt: 18.04.16
Sijainti: Kempele, Suomi
Viestit: 700
|
|
Lainaus:
Alkuperäinen kirjoittaja 1fzpower
The stock mounts needed to be about 1/2 from the inside flange, so no way to get the bolts out to pull the portal apart, so moved them about 1" away and mounted them there. Then I cut off the spring perch and raised it 3/8 inch and will weld it back in the correct spot. This should give enough area to unbolt; however, these bolts don't have enough room to come out.... CLOSE.
|
Can stud bold be used?
|