kopio varsien myynti tekstistä.
Crossover steering is simple and allows for far more suspension travel than a stock style setup. While you are doing the conversion why not raise your vulnerable steering tierod away from the rocks? These high steer / crossover steering arms are for the hardcore do-it-yourselfer. The arms come with a .640" hole. The reason this is our default size is that it will accommodate a 5/8" bolt, its also the predrill size for tapered (TRE) holes and it can be easily drilled out to 3/4" or whatever size you desire.
The arms are waterjet machined from 1" A36 hot rolled steel so there is no warpage or brittle steel due to extreme heat associated with laser and plasma cut arms. If you are on a budget and think you need to skimp on steering think again.
These arms have an angle milled on them (top and bottom) to compensate for the angle of your knuckle. The distance end to end of arm approx 9".
Made in Virginia with pride, these high steer / crossover steering arms are a remarkable value. Give us a call so we can mill, drill, taper and/or powdercoat these arms to your liking. We also supply ARP studs, linkage, DOM tubing, etc. to fully complete your install. We can also mill and drill your flat top knuckles if needed.
We accept personal check, paypal and credit cards. Click or call 540-514-7596 for details. Email us with questions through ebay or directly at
matt@virginia4x4.com or visit our home page. Thanks!