Tässä hydronic 10:n ohje:
Delete fault memory
Condition:
An electrical connection exists from terminal 15 (ignition) to
the module timer, 12-pin connector, chamber 10.
• Correct cause of fault.
• Press button c –> The heater is switched on. (liekin kuva)
• Press button a,(kello) keep it depressed and then press button
p within 2 seconds.
The module timer is now in the „Enquire fault memory“
program.
• Switch off ignition (terminal 15).
• Simultaneously press button a (kello) and button p, in addition,
switch on the ignition (terminal 15) and wait until the
following appears in the display.
After ignition „ON“ the following appears in the display:
Display flashes, heater symbol does not flash
• Switch the heater off and on –> the control box is unlocked,
the heater restarts.
|