Viestiketju: Jeep Grand Cherokee ZJ
Näytä yksittäinen viesti
  #5  
Vanha 27.08.2014, 14:33
hitsaa hitsaa ei ole kirjautuneena
Aktiivijäsen+++
 
Rekisteröitynyt: 25.09.12
Sijainti: Stadi
Viestit: 420
Perusasetus

Lainaus:
Alkuperäinen kirjoittaja Jäpälä Näytä viesti
Oisko tietoa et minkä sulake on hanttarin jalkatilassa olevassa sulake rasiassa numero 8, 20 amp roppu siinä olis. Sen kautta "vuotaa" 0,1 amp johonki, mutta kun sen sulakkeen irrottaa niin mielestäni kaikki laitteet toimii ihan normaalisti.
Autohan oli 96vm 4.0 larvanto
Lainaus:
Alkuperäinen kirjoittaja 8W-54 TRAILER TOW
TRAILER TOW—FACTORY INSTALLED
The factory installed trailer tow system in this vehicle uses three relays and a circuit breaker along with the trailer tow wiring connector.
Circuit A250 from fuse 11 in the Power Distribution Center (PDC) powers circuit F70 through fuse 8 in the junction block. Circuit F70 supplies battery voltage for the trailer tow circuit breaker and the contact side of the stop lamp relay
The trailer tow circuit breaker is taped to the trailer tow harness located in the left rear quarter panel.
...
TRAILER TOW—AFTER-MARKET
The after-market trailer tow connector is located in the left rear quarter panel. The connector contains feed circuit F70 from fuse 8 in the junction block.
Circuit L60 from the right turn signals, circuit L90 for parking lamps, and circuit L50 from the stop lamp switch.
Lainaus:
Alkuperäinen kirjoittaja 8W-61 POWER DOOR LOCKS
LIFTGLASS
Circuit A250 from fuse 11 in the Power Distribution Center (PDC) powers circuit F70 through fuse 8 in the junction block. If the liftglass limit switch is closed, it connects circuit F70 to the liftglass switch
(push button) on circuit P101. When closed, the liftglass switch connects circuit P101 to circuit P100.
Circuit P100 feeds the liftglass solenoid. Circuit Z1 grounds the solenoid.

Peräkärrin valot tai takaluukun lasin kytkin? Toivottavasti tästä on apua.
Vastaa lainaten